Shure MX184 Supercardidioid Lavalier Microphone
Supercardioid Lavalier Microphone with 50Hz-17kHz Response, Belt-clip Preamp, Tie Clip, and Windscreen
Description
The MX184 premium supercardioid lavalier microphone brings a new level of sophistication to personal voice reproduction. Like all Microflex family microphones, this lavalier uses an interchangeable condenser cartridge, meaning there will always be a lavalier to suit your application.
What is the MX184 best suited to?
The MX184 supercardioid miniature lavalier condenser microphone is designed for use in speech applications such as broadcast presenting, speeches, lectures and for use in houses of worship.
What is an interchangeable cartridge?
All the Microflex series of microphones use interchangeable cartridges (sold separately) which means you can swap between cardioid, supercardioid and omnidirectional condenser cartridges simply by screwing them on to the top of the lavalier mic.
Want to go wireless?
The MX184 is designed for wired use and includes an in-line preamplifier and a 1.2m cable with TA4F connector. If you wish to go wireless, choose the WL184 which is the same microphone but without the pre-amplifier and connects directly into any Shure wireless bodypack.
FEATURES
- Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum
- Interchangeable cartridges that provide an optimal choice for each application
- Rotatable tie-clip that pivots in 90 degree increments for placement flexibility
- Supplied snap-fit foam windscreen that controls breath noise and stays on securely
- Balanced, transformerless output for increased immunity to noise over long cable runs
- Supplied dual tie clip holds two microphones for dual miking applications
Spesifikasi
Transducer | Electret bias condenser |
Polar Pattern | Supercardioid |
Frequency Response | 50 Hz to 17 kHz |
Dynamic Range (Typical) | 94 dB (@ 1 kHz, A-Weighted) |
Signal-to-Noise Ratio | 66 dB |
Maximum Input Sound Level | 122 dB (@ 1 kHz, 1% THD) |
Power Requirements | 11 – 52 VDC (with belt clip preamp) |
Output Impedance | 150 ohms (180 ohms actual) |
Output Connectors | XLR-3M type |
Low Frequency Roll-Off | None |
Applications | Radio, videography, television and broadcast |
Dimensions | Microphone housing: .85 x .46″ (22 x 12 mm) LxDiameter In-line pre-amp: 3.89 x .79″ (99 x 20 mm) LxW Cable length: approximately 4′ (1.2 m) with TA4F connector |
Package Weight | 0.9 lb |
Box Dimensions (LxWxH) | 10 x 4.7 x 3.2″ |